請問para acoustic di的fx loop怎麼接?

本文由 garage11472013-10-07 發表於 "效果器、Amp、DIY" 討論區

  1. garage1147

    garage1147 Member

    註冊日期:
    2011-07-11
    文章:
    139
    讚:
    0
    買了para acoustic di,但想要再串接一些效果器,上面只有一個fx loop的孔,不像音箱有send、return兩個孔,所以我查了官網的說明書如下:

    Effects loop: This jack provides a send-return on a stereo jack for outboard effects that allow you to blend reverb, chorus or other effects in with a dry signal. Use an insert cable (stereo plug with a Y cable to two mono plugs) to connect the effect. The tip is the "send" and goes to the input of your effect. The ring is the "return" and comes from the output of your effect, and the sleeve is the ground. You may adjust the amount of
    effect in the signal by using the controls of the outboard effect. The send (tip) of this connector comes directly from the pure class A discrete input stage of the Para D.I., before the EQ, volume control, invert switch and output driver. Therefore it can be used as an immaculate, unbalanced direct output. It will not be affected by any of the panel controls (with the exception of the gain control). Use a regular mono cable. The effects loop interrupts the signal path. Therefore, it may also be used as an insert point for a compressor, volume pedal, or tuner if the tuner has a bypass switch.

    所以他的fx loop是同一個孔進出嗎?我需要訂做一條stereo轉兩條mono的線,再串接我的踏板?是這樣嗎??

    我看不大懂,查了單字也不是很確定,請各位幫我看一下,謝謝!
     
  2. joe.p

    joe.p Member

    註冊日期:
    2002-11-14
    文章:
    143
    讚:
    1
    是的!!就是這麼作~Stereo的phonejack插在DI FX LOOP孔上~分接出Mono的兩條線來接效果器!我以前是這樣接reverb的~good luck
     

分享此頁面